Delta Ligero custom radiators are in place!

Work has been progressing at a steady pace on the Delta Ligero prototype, with Andrew at Tricky Performance Engineering honing in on the rear end of the car and concentrating on the radiator and exhaust systems. The main consideration for the radiator setup for the car was naturally primarily to provide an abundance of cooling capacity for whatever engine the Ligero ends up getting, with a little extra capacity to account for forced induction if we go down that path. A secondary consideration was the weight impact of the radiators and their full coolant load, with the goal of the system as low to the ground, and as close to the centre of the car as possible to minimise any potential impact on handling. After considering all of our options for single versus twin radiator systems, and various mounting positions, we went with a set of RX7 type radiators mounted one on either side of the car, just aft of the rear wheels. This position will allow optimal airflow to be ducted from the hip and shoulder air intakes of the car, through the radiators, and then out through the vents in the back panel. Once sourced, the radiators had to be modified somewhat to suit our needs, and all the piping in and out is custom.

The radiators fit snugly inside the rear wheel arch, in between the outer bodywork and the 45 litre aluminium fuel tanks on either side.

 

From the rear of the engine bay looking forward the view looks like this:

We’re expecting the exhaust cans to come back from the fabricator in the next week or so and their mounts are eagerly awaiting their arrival! 

The mockup of the exhaust cans, as well as their dimensions drawn on the outside of the bodywork,  can be seen below. 

The plan will be for the car to head back to Joe Bradley Fibreglass once the exhaust cans are in place for the next phase of bodywork to complete the rear wheel arches and a duct system to feed the radiators and vent hot air out through the back of the car.

Thanks for looking! Until next time…